What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 27.06.2025 00:29
These are simplified answers to the original question, and does not change anything I wrote above.
(Dc diagram shown, AC is similar).
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Trump threatens ‘very serious consequences’ if Musk backs Democrats - The Washington Post
Upvotes:
eight
nine
On Which Part of the Body Might One Wear Winklepickers? - Slate Magazine
This is where the MOV conducts again, and dissipated the energy.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Why do Argentinians use "vos" instead of "tú" in informal speech?
At one ohm, the resistor has a maximum of 1 watt power.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
One is “what exactly is in a ‘surge protector’ ? ”
Texas governor vetoes hemp ban bill - Politico
[old diagram got deleted by accident]
what exactly is a ‘surge’ protector?
For this case there are devices called Metal oxide varistors (MOV).
Now when you have a certain ac resistance, then a current flows in a loop.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
What is unattractive about a nice guy? Why do some women don’t choose nice guys?
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
The bolt then partially travels down the line to your home.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Doctors use poo pills to flush out dangerous superbugs - BBC
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
There are two important concepts here.
but this device (an Inductor) … impedes the rapid changes in the current.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
A circuit breaker is similar, but is resettable.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
IBD 50's Hims & Hers Erases Its 19% Acquisition-Tied Sprint - Investor's Business Daily
He then describes Rainy Season and Lightning.
so, what happens?
Here is a simplified AC power diagram.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
In schematic diagrams this is the symbol for a fuse:
2024–10–10[John johnson John Johnson ]
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
the problem then depends on "how fast does the fuse operate?".
He then describes the function of a fuse.
It seems Mohan does not understand the difference between a comment and an Answer.
What is lightning?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
There are three different concepts here that are getting confused.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
So, the voltage could go up to 500 volts, and the fuse will not open up.
How do I study with focus and concentration and avoid distractions and procrastination?
2024–10–14 [Omar Gharbi Omar Gharbi ]
The third is lightning and “how it gets conducted into a home.”
This is the picture of an electronic coil of wire wound around a core of magnetic material.
But it can get overloaded, and no longer works.
An AC voltage/ current source, and an ac inductive load.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
This device then solves the entire problem.
a photo is worth a thousand words.
What does a fuse do?
but I think this circuit , shows a few more pieces.
At least they know the answer if they wanted it.
This is 'the assistant's answer'
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This one hit behind the barn.
First Sentence:
2024–10–16 [ OO OLAOYE OYEBODE ]
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
But… the neutral is now “floating” because of the 1 ohm resistance.
I post the exact comment here.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Barnstars:
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
The other is “what does a “fuse” do?”
One
He then asserts :
Because the load is inductive, the current lags the voltage.(by a bit).
[image of Common-mode choke]
Edit 2024–10.
The MOV will conduct when the voltage exceeds 50% of line voltage.
It also is a device that limits the change in current flow.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
A fuse is a non-resetable over current circuit protector.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
These devices are installed between the “hot” and “neutral” and protective ground.
This is where this question deviates from being a 'generic' question, and becomes more specific.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”